R-Motion®
Thinner core and optimized tip for lower dentine stress with enhanced cyclic fatigue resistance (manufacturer data)
AlloyHeat-Treated NiTiFile7Verified
Specifications
Tap icons for term definitions
| File | Tip | Taper | Motion |
|---|---|---|---|
| R-Motion Glider | 0.15 | 3% variable (3% first 9mm then 6%) | Reciprocating |
| R-Motion Glider C | 0.15 | 3% variable | Reciprocating |
| R-Motion 20 | 0.20 | 4% | Reciprocating |
| R-Motion 25 | 0.25 | 6% | Reciprocating |
| R-Motion 30 | 0.30 | 4% | Reciprocating |
| R-Motion 40 | 0.40 | 4% | Reciprocating |
| R-Motion 50 | 0.50 | 4% | Reciprocating |
Clinical Tips
Most cases require only 2 instruments: Glider + one shaping file
Compatible with any endo motor offering reciprocating counterclockwise mode
FKG Rooter X3000/X4000 has auto-preset for R-Motion (F: auto, R: auto in REC mode)
Manufacturer reports improved cyclic fatigue resistance, flexibility, and reduced dentine stress vs standard reciprocating systems (internal lab data — exact figures not independently verified from accessible primary sources)
Heat-treated NiTi allows pre-bending for curved canal access
Electrochemical polishing provides smooth surface finish
Rounded triangular cross-section optimizes cutting efficiency and debris removal
Thinner core design reduces dentine stress during instrumentation
Warnings
- Must use reciprocating (CCW >> CW) motor settings - never continuous rotation
- Single use only - cannot be resterilized or reused
- Contains nickel-titanium and silicone — do not use on patients with known sensitivity (per IFU)
- Do not force file apically - let it progress passively
- Clean flutes frequently and check for signs of distortion or wear
- If a file does not easily progress, remove and inspect before re-inserting
- Performance claims (3.6x fatigue, 42% flexibility, etc.) are manufacturer-reported internal lab results
Obturation Techniques
Single cone, warm vertical, carrier-based & lateral compaction
Protocol
01Glide Path
02Shaping
03Finishing
Related Systems
From FKG Dentaire Systems
Manufacturer page
FKG Dentaire SystemsOther reciprocating systems
Motion category
Reciprocating MotionCollections
Clinical guides
Frequently Asked Questions
01What alloy is R-Motion made from?
01
What alloy is R-Motion made from?
Answer
R-Motion® is manufactured from Heat-Treated NiTi with other heat treatment.
02How many files are in the R-Motion sequence?
02
How many files are in the R-Motion sequence?
Answer
The R-Motion® system includes 7 files: R-Motion Glider, R-Motion Glider C, R-Motion 20, R-Motion 25, R-Motion 30, R-Motion 40, R-Motion 50.
03What motion type does R-Motion use?
03
What motion type does R-Motion use?
Answer
R-Motion® uses reciprocating motion.
04What cases is R-Motion best for?
04
What cases is R-Motion best for?
Answer
R-Motion® is best suited for: minimally invasive reciprocation, lower dentine stress, wide curvature accommodation.
05What speed and torque settings are recommended for R-Motion?
05
What speed and torque settings are recommended for R-Motion?
Answer
R-Motion® uses reciprocating motion with manufacturer-specific motor settings (refer to official DFU for exact parameters).
Reviewed by
Uzm. Dt. Levent Yüksel
DDS · Endodontist
Independently authored and clinically reviewed.
Powered by:Uzm. Dt. Levent Yüksel